The program for planning and calculating the flight route of the aircraft (helicopter) using the Jeppesen air navigation information cards. Allows you to pave and calculate the route for a specific type of aircraft. Consists of three parts. Updated once every two weeks. JepPView program - electronic reference material, you can also print the necessary airport schemes - all Jeppesen (cards, airport schemes, etc.), FLITESTAR / FLITEMAP is a program for automatic planning and calculating the flight route, printing the on-board magazine with flight calculation, It is also possible to connect GPS and use as a navigator, FliteDeck - GPS navigator for use in flight (GPS receiving is required). Included everything you need to install.

Extra. information:
Coating Code - Full Worldwide: 145FH39350
Duration: 14 / May / 2021 - 27 / May / 2021
First installation
If you install the program for the first time, use the following installation code:
The code:
VNX1-IBYH-E5K1-7G8F
After the program is installed, for the first start, select "Activating by phone" and enter the following code:
The code:
R00D-KCAB.
For each cycle there are certain coverage codes.
Also, I recommend using a C disc to install (when installing on another disc, problems may occur).

Comments on use

The installer will offer you to install Jeppesen CDA Service. It is not required to use JepPView 3 and is probably not required to use JepPView for Windows. There is a likelihood of problems, so I recommend to cancel this part of the installation when it will be offered.
After installing the updated data, JEPPView 3 may still complain about outdated data. To solve this problem, go to:
The code:
C: \ ProgramData \ Jeppesen \ FliteDeck3
And copy the whole folder "Enroutedata" in:
The code:
C: \ ProgramData \ Jeppesen \ JeppView3
When prompted, reboot.


Other coating codes
https://pastebin.com/WdPKcN3L

Release Date: 2021
Version: 2110
Developer: jeppesen.
Interface language: English
Tabletka: Not required
System Requirements: Windows 7, 8, 10

ww2.jeppesen.com