Program for planning and calculating the flight route of an airplane (helicopter) using aeronautical information maps from Jeppesen. Allows you to automatically plot and calculate a route for a certain type of aircraft.

Consists of three parts. JeppView program - for viewing reference material in electronic form, you can also print the necessary airport layouts - the entire Jeppesen (maps, airport layouts, etc.), FliteStar / FliteMap - a program for automatic planning and calculation of the flight route, print the flight log with calculation flight, it is also possible to connect a GPS and use it as a navigator, FliteDeck - a GPS navigator for use in flight (requires a GPS receiver).

This message contains only the service pack for these utilities and is installed as an update AFTER installing these utilities. These service packs are released every two weeks. Please browse the forum to install these listed utilities, they are easy to find.
Add. Info: Coverage Code - Full Worldwide: 132JI38151
For other coverage codes, see below.
Usage Notes

The installer will prompt you to install the Jeppesen CDA Service. This is not required to use JeppView 3 and probably not required to use JeppView for Windows. This will mostly cause you problems, so I recommend canceling this part of the setting when it appears.
After installing updated data, JeppView 3 may still complain about stale data. To fix this problem, go to:
The code:
C: \ ProgramData \ Jeppesen \ FliteDeck3
and copy the entire "EnrouteData" folder to:
The code:
C: \ ProgramData \ Jeppesen \ JeppView3
Overwrite on request.
As you enter coverage code sequences from the Easy Entry list below, you will notice that the setting does not display new coverage areas after a while. This is fine because the installer will actually install all of the areas for which you entered codes, even if they do not appear in the window.



Other coverage codes
The code:

https://www.anonymz.com/?https://pastebin.com/VWbjw0Vf

ww2.jeppesen.com